Uneven Density Within 90 Mm (3.5 Inches) Of The Trailing Edge - Ricoh Pro C7500 Original Instructions Manual

No Start over from Step 2. If the problem persists even after decreasing the value to
"-10", there is no other solution.
Select the best sample printout and print under that condition.

Uneven Density within 90 mm (3.5 inches) of the Trailing Edge

Printing in the area extending approximately 90 mm (3.5 inches) from the trailing edge is fainter or
denser.
Occurrence conditions:
• Printing is done at low temperature or humidity
Solution:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, select 1341: [Motor Speed], and then decrease
the line speed of the 01: [Transfer Timing Roller] by 0.1%.
3. Check to see if uneven density has been resolved.
Yes Finished!
No Start over from Step 2.
Decrease the value in steps of 0.1% within the range down to -0.5%, and then
apply the optimal result.
90 mm
(3.5 in.)
90 mm
(3.5 in.)
CEZ564
Uneven Density
59