Ricoh Pro C7500 Original Instructions Manual page 164

5. Image Quality Problem: Lines/Streaks
• 1212-07: Image Transfer Output: FC/FCS: White
• 1212-08: Image Transfer Output: FC/FCS: Metallic
• Increasing the value may increase the density. As required, execute process Setting and
calibration.
• The page yield becomes affected.
• Photoconductor-related ghosting may occur.
• Small-pitch banding may worsen.
11. In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed], and
then decrease the value in the following corresponding settings by one level.
Productivity Priority
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
High Quality
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
For example, if the print speed is [High], decrease it to [Middle], and if decreasing the speed to
[Middle] does not have a sufficient effect, decrease the speed to [Low].
If it is already set to [Low], there is no other solution.
12. Print the image. Has the problem been resolved?
Yes
162
Finished!