Ricoh Pro C7500 Original Instructions Manual page 169

2. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Start over from Step 1. If the problem persists even after executing [Belt Scratches]
5 times, go to the next step.
3. If the fuser unit can be replaced, replace the fusing unit, and then go to Step 5.
For details, see "123 Fuser Unit", Regular Maintenance Guide.
4. In [Detailed settings] for custom paper, select 1240: [Fusing Nip Width: Paper Type], and
then check the value for 01 [Type].
Other than envelopes Proceed to "If the paper type for fusing nip width is set to "other than
Envelope
5. Check whether or not to enable [For Belt Scratches] in [Interval] in [Fusing Belt
Smoothing].
• With this function, the fusing belt smoothing roller automatically polishes the surface of the
fusing belt after a certain number of sheets have been fed. (Automatic polishing)
• Normally, this is set to "Off (Do not Execute)".
• The higher the frequency of polishing, the shorter the replacement cycle of the fusing belt
smoothing roller becomes.
Yes Go to the next step.
No Finished!
6. Enable [For Belt Scratches] in [Interval] in [Fusing Belt Smoothing].
1. Select the paper from the Master paper, change the paper name to "(Paper Name)
Refreshing", and register it as custom paper.
2. In [Detailed settings] for custom paper, select 1243 [Fusing Belt Smoothing], select [Interval]
in 02: [For Belt Scratches], and then adjust the setting.
• You can select the frequency of polishing from among "Frequently", "More Frequently" and "Most
Frequently".
• Be sure to change the frequency in the order of "Off", "Frequently", "More Frequently", and "Most
Frequently".
envelopes".
Proceed to Step 5.
Streaks
167