12. Problems Related to Throughput
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if the image is wiped with an optical cloth.
Yes
No
4.
In [Detailed settings] for custom paper, select 1231: [Motor Speed], and then change the
print speed from [High] to [Middle].
If it is already set to [Middle] or [Low], go to Step 6.
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
5.
Print and check if the issue is within the acceptable range. (Print 10 or more A3 sheets.)
Yes
No
6.
Change the print speed to "Low".
7.
Print and check if the issue is within the acceptable range. (Print 3 or more A3 sheets.)
Yes
No
322
Finished!
If the fusing heat roller temperature has not yet reached 185°C, start over from
Step 2.
If the problem persists even after reaching 185°C, go to the next step.
Finished!
Go to the next step.
Finished!
Go to the next step.