Ricoh Pro C7500 Original Instructions Manual page 173

4. Select 1232 [Fusing Temperature], and then check the fusing heat roller temperature
settings for every mode except for the mode for the special color (clear).
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
175°C or less
176°C or higher
5. Except for the mode for the special toner (clear), increase the fusing heat roller
temperature by 10°C.
6. Go back to 1232: [Fusing Temperature] and then change it to "Middle".
7. Print on 20 or more sheets of A4 paper, short edge feed (SEF), to check if the image is
within the acceptable range.
Yes Go to the next step.
No Proceed to "Increasing the Fusing Heat Roller Temperature to 200°C / Decreasing
the Print Speed to "Low"".
• If paper jams occur, you can increase margin width according to the troubleshooting
described in see page 252 "Paper Jams Occur with Crumpling of the Leading Edge When
Thin Paper Is Used".
8. Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
Go to the next step.
Proceed to "Increasing the Fusing Heat Roller Temperature to 200°C /
Decreasing the Print Speed to "Low".
Streaks
171