Uneven Density Within 90 Mm (3.5 In.) Of The Trailing Edge - Ricoh Pro 8300S Troubleshooting Manual

2.Image Quality Problems
Yes Finished.
No Decrease the scaling factor by 5 percentage points.
3. Repeat Step 2. If the problem persists even though you have decreased the scaling factor by 50
percentage points, restore to the value noted in Procedure (b) Step 1, and then consult the product
specialist.

Uneven Density Within 90 mm (3.5 in.) of the Trailing Edge

Printing in the area extending approximately 90 mm (3.5 inches) from the trailing edge is fainter or
denser.
Cause:
This may occur when:
 Printing is done at low temperature or humidity
Printing a single-dot halftone image

To adjust the following settings, register beforehand the type of paper that you are using as a

custom paper.
Solution:
The solution depends on whether the area within 90 mm (3.5 inches) of the trailing edge is denser or
fainter. However, if the paper is not registered as a custom paper, then adjust the speed of the timing
roller.
If the area within 90 mm (3.5 inches) of the trailing edge is fainter
1. In Advanced Settings for the custom paper in use, check the present value in Transfer Timing
Roller Feed Speed Adj. Is it higher than +1.0%?
Yes
No
2. Increase the value in Transfer Timing Roller Feed Speed Adj by 0.1 percentage point.
3. Print the image. Is the problem resolved?
Yes Finished.
No Repeat Steps 2 and 3. If the problem persists even though you have increased the value
to +1.0%, consult the product specialist.
674
Consult the product specialist.
Go to the next step.