Table of Contents
Advertisement
Removing memory
Installing or removing RAM
The Matrox Supersight SHB boards feature slots in which you can install RAM
modules. The Matrox Supersight SHB-Q170 has four 288-pin DDR4
Long-DIMM slots, and each slot supports a Long-DIMM memory module of up
to 16 Gbytes in size. The total memory on the Matrox Supersight SHB-Q170 can
be up to 64 Gbytes.
To remove the existing memory module(s) from the Matrox Supersight SHB
board:
1. Open the chassis by following the steps explained in Removing the chassis cover,
earlier in this chapter.
2. Remove the SHB from its slot and place it on a static-free flat surface.
3. Spread the clips at each end of the DIMM slot.
DDR SDRAM
4
Clip
Long-DIMM slot
DDR4 SDRAM Long-DIMM module
4. Lift the module out of the slot.
Connecting devices to the internal connectors of the SHB
Long-
DIMM module
Clip
Notches
SHB-Q170
Matrox Supersight
board with
four
DIMM slots
55
Advertisement
Table of Contents
