Table of Contents
Advertisement
Removing the retainer guide
The Matrox Supersight SHB boards and PCIe boards installed in your Matrox
Supersight are held in place with a retainer guide and plastic holding clips. When
adding a new board to your Matrox Supersight unit or adding/removing memory
from a Matrox Supersight SHB, the retainer guide must first be removed. To do
so, perform the following:
1. Remove the screw holding the retainer guide in place.
2. Loosen the tightening screws on the plastic holding clips and rotate them up and
away from the board.
3. Lift the unscrewed end of the retainer guide up and slide the other end out.
Screws
Removing the retainer guide
Retainer
clips
Screws
Screw
Retainer
guide
37
Advertisement
Table of Contents
