Table of Contents
Advertisement
SHB
The Matrox Supersight SHB-Q170 board complies with the PICMG 1.3
specification, implementing one x16 and one x4 PCIe interface. The board
intergrates the following functionality:
• Processing. Processing comes from one Intel i7-6700 processor. This processor
uses technologies designed to accelerate multimedia and imaging applications.
The processor uses multimedia extension (MMX) technology, streaming SIMD
extensions (SSE, SSE2, SSE3, SSSE3, and SSE4) technology, and EM64T (Intel
64 architecture) technology. These technologies are extensions to the Intel
architecture, which address the key characteristics of applications that must handle
large amounts of image, video, and graphics data.
• Display. Display capabilities come from a dedicated graphics controller. The
graphics controller allows you to send analog video data to one high-resolution
analog display device and one single-link DVI-I display device. The maximum
display resolution is 2560 x 1600 with 24 bits/pixel.
• Memory. Memory comes from the DIMM memory modules installed in the four
DDR4 288-pin DIMM slots; each slot supports a DIMM memory module up to
16 Gbytes in size. The DDR4 modules run at up to 1067 MHz (DDR4-2133).
The total amount of memory can be 64 Gbytes.
• Mass storage. Mass storage comes from a 2.5-inch SATA hard disk drive,
connected to the SHB. Each SHB must be connected to a mass storage device
containing its operating system; without it, the SHB cannot boot. A hard drive is
included with each SHB. The SHB has three on-board SATA connectors.
• Networking. Networking comes from the two integrated Gbit Ethernet
interfaces. Each Gbit Ethernet interface supports 10BaseT, 100BaseT, and
1000BaseT, which can be used to connect the Matrox Supersight SHB-Q170
board to your network.
• BIOS. The BIOS is stored on an on-board flash memory device. The BIOS acts
as an interface between the operating system and the Matrox Supersight
SHB-Q170 board.
SHB
15
Advertisement
Table of Contents
