Installing A Mass Storage Device Drive - Matrox Supersight Installation And Hardware Reference

54 Chapter 3: Connecting devices to the backplane and to the Matrox Supersight SHB board
10. Re-install the chassis cover by reversing the steps described in the Removing the
11. Reconnect the power source to the unit, and restart each Matrox Supersight SHB.
7. Place the new DVD drive onto the drive tray, and attach it to the drive tray.
8. Connect the SATA cable connector from the back of the DVD drive to the
specified SHB.
SATA connector
SATA plus power connector
(connect to back of the DVD drive)
9. Connect the SATA LP4 power connector to one of the 4-pin peripheral power
cables of your Matrox Supersight unit's power supply. Always use the shortest
power cable possible to connect both the DVD drive and mass storage drive to
your Matrox Supersight backplane. This helps avoid having cables getting
squeezed or worn.
chassis cover, earlier in this chapter.

Installing a mass storage device drive

The procedure to install a new hard disk drive or a solid state drive (SSD) is
identical to the procedure for Installing or replacing an optical disk drive described
earlier in this section.
Power connector