Table of Contents
Advertisement
94 Appendix B: Technical reference
Connectors
SHB slots
x16 PCIe 2.0 connectors
x8 PCIe 2.0 connectors
USB headers
Backplane power connectors, 24-pin
Unit fan connectors
Voltage rail LEDs
*. Depending on the number of SHB's connected, you can have a maximum of six x16 PCIe boards, and either four x8 PCIe boards or an additional two x16 PCIe
boards.
†. For the 13-connector version, you can have either seven x16 PCIe boards and one x8 PCIe board or thirteen x8 PCIe boards.
‡. For the 8-connector version, you can have either four x16 PCIe boards or eight x8 PCIe boards.
Automatic power-up connector ("JPATATX1" header)
The automatic power-up connector on the Matrox Supersight SHB-Q170 is a
3-pin standard, 2 mm spacing, male connector. It allows you to automatically
power the Matrox Supersight SHB-Q170 upon power up of your Matrox
Supersight unit. You must install a jumper on this connector when the Matrox
Supersight SHB-Q170 is located in connectors 2, 3, or 4 of a Matrox Supersight e2
unit.
Jumper installed on Pins
1-2
2-3d
Pinout descriptions of backplane connectors
and LEDs
You will find the following internal connectors on the backplane:
PCIe backplane in the
Matrox Supersight e2 unit
4
*
8
*
4
3 (10-pin)
3
3 (4-pin)
6
↑ Edge of board ↑
1 2 3
Description
Matrox Supersight SHB-Q170 will automatically power up when your Matrox
Supersight powers up.
Matrox Supersight SHB-Q170 will not automatically power up.
Type of switched fabric backplane
PCIe backplane in the
Matrox Supersight Solo unit
1
†
‡
7
or 4
†
‡
13
or 8
3 (10-pin)
3
3 (4-pin)
5
Advertisement
Table of Contents
