Maintenance/Repair - Hertz IMPETUS Series User Manual

Some components (airend, radiator, oil tank, oil filter etc.) inside your compressor may reach high
▪
temperatures during operation and may cause burns upon contact. Do not contact these surfaces.
Do not overlook that the oil used in the system can also reach high temperatures while compressor
▪
is running.
When oil leaks from your compressor, do not interfere by hand and shut down your compressor by
▪
the emergency stop button and switch the main switch to off position.
Do not touch or make a move to check your compressor while it is running. Do not use sticks, cables
▪
etc. for this.
Keep away from all air outlets of your compressor (safety and discharge valves, nozzles, etc.). The
▪
air discharged from the air exits are hot and can cause injuries.
Operate your compressor only where there is adequate ventilation.
▪
Keep your body, hand tools and conductors away from the current passing parts of your compressor.
▪
You must keep the electrical panel cover closed while the compressor is running; If necessary stop
▪
your compressor and cut off its power from the main switch.
Ensure that the moving parts inside the compressor run without brushing against anything.
▪
Operate your compressor in the environments with temperature range between 35 F° (2 C°) and 113
▪
F° (+45 C°).
Make the last controls before you start your compressor.
▪
Please be reminded that HERTZ KOMPRESSOREN's written approval is required for other operating
▪
conditions not specified in the user manual.

1.6 Maintenance/Repair

Stop your compressor before you remove or replace compressed air line components (filter etc.).
▪
Ensure that the compressed air inside the compressor is discharged (by checking the manometer).
Ensure that your compressor is shut down by main switch during any maintenance, cleaning or
▪
similar operation.
Do not change the safety valve and pressure switch, have them checked periodically.
▪
Ensure that the electrical and pressure connections of your compressor remain in good condition.
▪
Check the connections at the intervals stated in the maintenance period. Contact our authorized
service when you detect a damaged cable and pipe.
Ensure that your feet are not on wet ground and you work on an insulating material during
▪
maintenance, repair or adjustment of electrical parts.
Try to perform all works regarding electrical parts with right hand and single hand. This will decrease
▪
the risk of current reaching the heart in case of a possible electrical leak.
Ensure that no parts, cleaning agents and hand tools remain around your compressor after any
▪
repair, maintenance and calibration operation performed on your compressor.
Repair and correction works must be performed in a dry, clean, ventilated environment on an
▪
insulating layer.
Kompresörünüzü temizlemeden önce durdurduğunuza ve enerjisini tamamen kestiğinize emin
▪
olunuz.
Ensure that you stopped your compressor and completely cut off its power before cleaning it.
▪
If the inside of your compressor is big enough to have a living being inside or a process is made by
▪
the related people inside, then the other personnel must be informed about this and the covers of
the compressor must be kept open during the process.
All publication rights of this instruction manual belong to HERTZ KOMPRESSOREN. The manual cannot be reproduced, changed or distributed wholly or partially in any way.
HERTZ KOMPRESSOREN has the legal rights of this user manual and all instructions or parts. Any sampling, sharing or copying are prohibited.
6