Table of Contents
Advertisement
Be careful and act slowly while carrying the compressor. Impacts and falls may cause damage to the
▪
internal components of the compressor and prevent it from operating.
Make sure that there are no living things under the compressor as you lift and lower it.
▪
Make sure that the floor you shall place the compressor on has the strength to support the
▪
compressor's weight.
1.4 Installation/Mounting
Ensure that all the electrical cables of your compressor are plugged in, and that there is no
▪
looseness and deformed cables. Remove deformed and loose cables immediately for your safety.
Aside from the recommendations and information presented in this guide, your compressor shall
▪
be installed in accordance with all national and international standards. All electrical installation
connections of your compressor must be made by authorized technicians.
Please ensure appropriate grounding is made on your compressor. Ensure that the grounding
▪
cable is connected to the marked part on the electrical panel of your "PE" compressor.
Install your compressor away from the sanding machine, kiln, chemical treatment machines and
▪
all kinds of flammable, dusty, humid, hot, chemical environments where the generators and
forklifts operate. It may cause high cost malfunctions such as compressor oil deterioration and
damage to the screw group in the compressors, which operate in such corrosive environments.
Ensure that all protection and safety parts are in place. Do not operate your compressor without
▪
replacing any damaged parts and installing any missing parts.
Ensure that moving parts are not in contact with other parts.
▪
Ensure that all electrical cables are connected to the necessary places on the compressor.
▪
Carefully check all connections after the installation of your compressor and before the first run.
▪
Air hoses should be in the correct sizes and conform to the operating pressure. Never use worn,
▪
damaged or old hoses. Distribution pipes and their connections should be in the correct sizes
and conform to the operating pressure.
1.5 Operation
Do not allow oil deposits to form outside the cabinet of the compressor. When necessary, clean these
▪
areas with non-flammable special cleaning materials.
Do not close the exit valve while the compressor is running, or do not operate the compressor while
▪
the exit valve is closed. Otherwise, your compressor may stop with high pressure error.
Do not operate your compressor with excessive capacity unless it is modified. Do not operate your
▪
compressor above its capacity unless necessary changes are made by the authorized service of
Hertz Kompressoren.
Do not operate the compressor with the coupling and fan housings removed.
▪
Keep your hands, arms and clothes away from rotating parts as much as possible. When a situation
▪
arises that requires you to approach rotating parts, ensure that you do not wear loose clothing.
Cabin covers might shut down with the impact of intake fan while the compressor is running. Ensure
▪
that your hand and fingers are not caught in such a case.
If your compressor shall be used with remote control, ensure that the related warning indicators
▪
display this status. This way, a user near your compressor can be aware of this state and understand
that he/she should stand in the safety distance.
All publication rights of this instruction manual belong to HERTZ KOMPRESSOREN. The manual cannot be reproduced, changed or distributed wholly or partially in any way.
HERTZ KOMPRESSOREN has the legal rights of this user manual and all instructions or parts. Any sampling, sharing or copying are prohibited.
5
Advertisement
Table of Contents
