Table of Contents
Advertisement
LIFTING
Caution : Moving the printer may affect settings (alignments, calibration . . .) . Contact your 3D Systems-
certified Customer Support Engineer to check the operation of the printer after moving.
When moving the ProX
DMP200 system, follow the instructions outlined below :
®
•
The system must only be lifted by authorized people.
•
Make sure entire lifting, rigging and supporting structure has been inspected, and is in a good condition.
•
The main cabinet can be moved by using a forklift with a load capacity of at least 1500 kg (3307 lbs), with minimum fork
length of 1500 mm (59.05 in.).
•
The control/supply cabinet is easily moved as it is equipped with transport wheels.
3D SYSTEMS, INC.
32
Advertisement
Table of Contents
Need help?
Do you have a question about the ProX DMP 200 and is the answer not in the manual?