Table of Contents
Advertisement
10. Use a lamp to observe the lens in order to check for any traces of dirt (5).
11. Repeat these steps until the lens is clean.
Caution: comply with the following steps in order to ensure the correct positioning of the head after
opening .
12. Make sure the mechanical stop is clean (6).
13. Make sure the head-lens support contact is clean (7).
14. Ensure the cleanliness of the bellows and the lens cleaner diffuser (8).
15. Close the head-lens assembly, making sure that the mechanical stop is in localized contact with the head-lens support
(9).
16. Tighten the assembly (9).
Excessive tightening could damage the localized contact .
3D SYSTEMS, INC.
Mechanical stop
Head-lens support
Bellows
Diffuser
Head-lens support
Mechanical stop
Tighten clamp
63
5
6
7
8
9
Advertisement
Table of Contents
