Table of Contents
Advertisement
WARNING: FIRE AND EXPLOSION HAZARDS . COMBUSTIBLE DUST INSIDE . METAL POWDERS ARE
FLAMMABLE AND POTENTIALLY EXPLOSIVE, ESPECIALLY WHEN DISPERSED IN A CLOUD AND EXPOSED TO
AN IGNITION SOURCE SUCH AS HEAT OR STATIC ELECTRICITY SPARK . OPERATORS AND SERVICE PERSONAL
SHOULD AVOID DISTURBING POWDER (MANIPULATE CAREFULLY TO AVOID AS MUCH AS POSSIBLE
SUSPENDING OF FINE PARTICLES) .
WARNING : FIRE AND EXPLOSION HAZARDS . PRESENCE OF METAL PARTICLE CONDENSATE INSIDE THE
MANUFACTURING CHAMBER . HIGHLY COMBUSTIBLE . DO NOT VACUUM, DO NOT BLOW . USE DAMP COTTON
CLOTH TO REMOVE THE METAL PARTICLE CONDENSATE .
WARNING : STATIC HAZARD . METAL PARTICLE CONDENSATES INSIDE THE PRINTER ARE HIGHLY
COMBUSTIBLE AND SHOULD BE KEPT AWAY FROM SOURCES OF POTENTIAL IGNITION . WEAR ANTI-STATIC
CLOTHING, ANTI-STATIC SAFETY SHOES, STAND ON GROUNDED ANTI-STATIC FLOOR PAD .
8.
Open the chamber door.
9.
Clean the sides of the manufacturing chamber with the use of a damp cotton cloth to neutralize any presence of the
condensate (black particle aspect).
Caution : Wear disposable rubber gloves and leather gloves during this step .
10. On the right silicon wiper, remove the 3 screws fixing the wiper.
11. Take out the wiper and separate the silicone blade to the subassembly.
12. Remove the used silicone blade, and place the new one on its support.
13. Gather the parts.
14. Set the subassembly on the machine : get the silicone blade touching the protection strip, then screw tightly the screws
removed at the step 10.
15. Proceed in the same way to replace the left silicon wiper.
16. Close the chamber door of the main cabinet, and tighten the captive screws.
3D SYSTEMS, INC.
Metal particle
condensate
- Highly
combustible
CHC M5 x16 Screws
91
Advertisement
Table of Contents
