Legal Notices; Copyright And Corporate Identity; Improvements; Fcc Notice - 3D Systems ProX 950 User Manual

Table of Contents

LEGAL NOTICES

proprietary information that is the property of 3D Systems, Inc. The licensed user, in the name of whom this document is

registered (the "Licensed User") does not have the right to copy, reproduce, or translate this document in any way or to any

media without the prior written consent of 3D Systems, Inc. No copies of the document may be sold or given to any person or

other entity.

3D Systems may (but shall not be obligated to) make improvements to this document from time to time. However, the Licensed

User acknowledges that at any time after the expiration of the date of issuance, 3D Systems may institute a periodic charge or

fee payable by the Licensed User in return for ongoing receipt of improvements. It is the responsibility of the Licensed User

to provide 3D Systems with current information as to its name and address. The Licensed User also undertakes to notify 3D

Systems promptly in the event that it considers any of the data contained in this document to be incomplete or erroneous in

any respect, in connection with Licensed User's particular or general use.

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated

in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of

this equipment in a residential area is likely to cause harmful interference in which case, the user will be required to correct the

interference at his own expense.

Changes or modifications not expressly approved by 3D Systems could void your authority to operate equipment.

This product generates 13.56 MHz using an Inductive Loop System as a Radio Frequency Identification device (RFID). This RFID

device complies with the requirements specified in FCC Part 15, Industry Canada RSS-210, European Council Directive 99/5/EC,

and all applicable local laws and regulations.

Operation of this device is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause undesired operation.

The device referenced in this guide contains transmitter, FCC ID: 2ADGF-SKTKM1 IC: 12666A-SKTKM1

The device referenced in this guide contains transmitter, FCC ID: 2ADGF-CLDRIDQK IC: 12666A-CLDRIDQK

Access to the transmitter for service technicians is available through common enclosure access methods including use of

common tools and removal of covers.

NOTE: Changes or modifications to this equipment not specifically approved by 3D Systems may void the user's

authority to operate this equipment .

3D Systems, Inc.

Table of Contents