Enabling Or Disabling Dual Time Mode - Hettich ROTINA 380 Operating Instructions Manual

Software operation
7.6.4

Enabling or disabling dual time mode

46 / 63
[PROG] button repeatedly until '-> Operating Time' is dis-
2. Press the
played.
[START] button.
3. Press the
'OP Time ext =' is displayed.
��
[PROG] button.
4. Press the
'OP Time int =' is displayed.
��
5. Press the [PROG] button.
'Number of Starts =' is displayed.
��
This is the number of all centrifugation runs.
[PROG] button.
6. Press the
'Cycles =' is displayed.
��
This is the number of run cycles (centrifugation runs) of the rotor
code used since the last cycle counter reset to
imum permissible number of run cycles.
[PROG] button.
7. Press the
'Rotor cycles total =' is displayed.
��
This is the number of all run cycles (centrifugation runs) of the rotor
code used.
[STOP/OPEN] button twice to exit the '-> Operating Time'
8. Press the
menu
or
[STOP/OPEN] button three times to exit the '***Machine
Press the
Menu***' .
It is possible to set when runtime counting starts during a centrifugation
'Dual time mode' function is enabled. The function is enabled ex
run if the
works.
The rotor is stationary.
1. Press and hold the
'***Machine Menu***' is displayed after 8 seconds.
��
[PROG] button repeatedly until '-> Settings' is displayed.
2. Press the
[START] button.
3. Press the
'SOUND / BELL = on' or 'SOUND / BELL = off' is displayed.
��
[PROG] button repeatedly until 'Dual time mode enabled' or
4. Press the
'Dual time mode disabled' is displayed.
[Rotary knob] to set 'enabled' or 'disabled' .
5. Use
disabled = The function is disabled
enabled = The function is enabled.
[START] button.
6. Press the
�� The settings are stored.
'Store Settings...' is displayed briefly.
'-> Settings' is then displayed.
[STOP/OPEN] button once to exit the 'Settings menu'
7. Press the
or
Press the [STOP/OPEN] button twice to exit the 'Machine Menu' .
Rev.: 04 / 11.2023
[PROG] button.
'0' and the max-
AB1701en_SA