Querying Operating Hours, Centrifugation Runs And Cycle Counter - Hettich ROTINA 380 Operating Instructions Manual
Hide thumbs
Also See for ROTINA 380:
- Operating instructions manual (176 pages) ,
- Operating instructions manual (72 pages) ,
- Operating instructions manual (105 pages)
Table of Contents
Advertisement
Disabling the cycle counter
7.6.3
Querying operating hours, centrifugation runs and cycle counter
AB1701en_SA
[RCF] button repeatedly until the maximum permissible
5.
Press the
number of run cycles is displayed in brackets á ñ.
6.
Use the
[Rotary knob] to set the maximum permissible number of run
cycles indicated on the bucket.
[START] button.
7.
Press the
�� The settings are stored.
'Store cycles ...' is displayed briefly.
The run cycles are displayed.
[OPEN/STOP] button twice to exit the 'Operating Time'
8.
Press the
menu
or
[OPEN/STOP] button three times to exit the 'Machine
Press the
Menu' .
The rotor is stationary.
1.
Press and hold the
'***Machine Menu***' is displayed after 8 seconds.
��
[PROG] button repeatedly until '-> Operating Time' is dis-
2.
Press the
played.
[START] button.
3.
Press the
�� The external operating hours are displayed.
[PROG] button repeatedly until, with the cycle counter ena-
4.
Press the
bled, the run cycles are displayed.
'Cycles = disabled' is displayed, the cycle counter is already disa-
If
bled.
[RCF] button repeatedly until the maximum permissible
5.
Press the
number of run cycles is displayed in brackets á ñ.
[Rotary knob] to set the maximum permissible number of run
6.
Use
'0' .
cycles to
7.
Press the
[START] button.
�� The settings are stored.
'Store cycles ...' is displayed briefly.
'Cycles = disabled' is displayed.
8.
Press the
[OPEN/STOP] button twice to exit the 'Operating Time'
menu
or
[OPEN/STOP] button three times to exit the 'Machine
Press the
Menu' .
The operating hours are divided into internal and external operating hours.
■
Internal operating hours
has been switched on.
■
External operating hours
runs to date.
The rotor is stationary.
1.
Press and hold the
'***Machine Menu***' is displayed after 8 seconds.
��
Rev.: 04 / 11.2023
[PROG] button.
'OP Time int =' : Total time for which the device
'OP Time ext =' : Total time of centrifugation
[PROG] button.
Software operation
45 / 63
Advertisement
Table of Contents
