Operation; Opening And Closing The Lid; Removing And Installing The Rotor - Hettich ROTINA 380 Operating Instructions Manual

Operation

6 Operation
6.1

Opening and closing the lid

Opening the lid
Closing the lid
6.2

Removing and installing the rotor

Removing the rotor with a
clamping nut
26 / 63
Personnel:
■
Trained user
The centrifuge is switched on
The rotor is stationary.
[STOP/OPEN] button.
Press the
�� The lid unlocks by means of a motor.
The light on the left side of the
CAUTION
Danger of crushing when closing the lid.
Danger of crushing fingers when the closing motor pulls the
lid against the seal.
−
No parts of the body should be in the hazard zone of the
lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
−
Close the lid slowly.
−
Do not slam the lid.
When the left side of the [STOP/OPEN] button flashes,
press the [STOP/OPEN] button so that the motorised lid
lock assumes the home position (open).
Personnel:
■
Trained user
Close the lid and press the front edge of the lid down gently.
�� The lid locks using a motor.
The left side of the
Personnel:
■
Trained user
Rev.: 04 / 11.2023
[STOP/OPEN] button goes out.
[STOP/OPEN] button lights up.
AB1701en_SA