Program Links; Linking Programs Or Changing A Program Link - Hettich ROTINA 380 Operating Instructions Manual
Hide thumbs
Also See for ROTINA 380:
- Operating instructions manual (176 pages) ,
- Operating instructions manual (72 pages) ,
- Operating instructions manual (105 pages)
Table of Contents
Advertisement
7.7
Program links
7.7.1
Linking programs or changing a program link
AB1701en_SA
[START] button.
6.
Press the
�� The setting is stored.
'Store Settings ...' is displayed briefly.
'-> Settings' is then displayed.
[OPEN/STOP] button once to exit the 'Settings' menu
7.
Press the
or
[OPEN/STOP] button twice to exit the 'Machine Menu' .
Press the
25 program links can be stored (program locations A to Z,
program location J does not exist).
A program link can consist of a maximum of 20 programs.
In a program link, the speed from one program to the next
is always adjusted with the ramp-up parameter of the next
program.
No centrifugation parameters can be changed in a program
link. Changing the parameters is only possible in the indi-
vidual programs.
No continuous operation programs or programs with ramp-
up and ramp-down times may be linked.
The [TIME] button can be used to retrieve the total runtime
of the program link and the runtime of the currently running
program during the centrifugation run.
Program links are enabled.
1.
Press the
[PROG] button repeatedly until 'EDIT A...Z ' is displayed.
[Rotary knob] to set the desired program location where the
2.
Use the
program link is to be saved.
[START] button.
3.
Press the
�� The program location of the program link and the first program of
the program link are displayed.
[Rotary knob] to set the first program of the program link.
4.
Use the
[PROG] button.
5.
Press the
�� The next program in the program link is displayed.
[Rotary knob] to set the next program of the program link.
6.
Use the
[PROG] button.
7.
Press the
�� The next program in the program link is displayed.
8.
Repeat steps 6 and 7 until all programs are set.
[Rotary knob] to set 'END' . For this, turn the rotary knob anti-
9.
Use
clockwise.
'END' can be set after the 20th program in the case of program
No
links consisting of 20 programs.
10.
Press the
[START] button.
'STO B' is displayed.
��
Rev.: 04 / 11.2023
Software operation
51 / 63
Advertisement
Table of Contents
