Operation
Immediate display of centrifu-
gation data after switching on
Switching off the centrifuge
6
Operation
6.1
Opening and closing the lid
Opening the lid
Closing the lid
6.2
Removing and installing the rotor
Removing the rotor with a
clamping nut
32 / 73
1.
Set the mains switch to
2.
Press and hold any button at the first visual change in the display
(inverse display).
Centrifugation data is displayed.
The rotor is stationary.
Set the mains switch to
Personnel:
■
Trained user
The centrifuge is switched on
The rotor is stationary.
[STOP/OPEN] button.
Press the
The lid unlocks by means of a motor.
The light on the left side of the
CAUTION
Danger of crushing when closing the lid.
Danger of crushing fingers when the closing motor pulls the
lid against the seal.
−
No parts of the body should be in the hazard zone of the
lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
−
Close the lid slowly.
−
Do not slam the lid.
When the left side of the [STOP/OPEN] button flashes,
press the [STOP/OPEN] button so that the motorised lid
lock assumes the home position (open).
Personnel:
■
Trained user
Close the lid and press the front edge of the lid down gently.
The lid locks using a motor.
The left side of the
Personnel:
■
Trained user
Rev.: 05 / 11.2023
[I] .
[0] .
[STOP/OPEN] button goes out.
[STOP/OPEN] button lights up.
AB5650en_SA