Switching The Centrifuge On And Off; Operation; Opening And Closing The Lid - Hettich MIKRO 220 Operating Instructions Manual

5.4

Switching the centrifuge on and off.

Switching the centrifuge on
Switching off the centrifuge
6

Operation

6.1

Opening and closing the lid

Opening the lid
Closing the lid
AB2200en_SA
Personnel:
■
Trained user
Set the mains switch to
�� The buttons flash, depending on the centrifuge type.
The following indicators appear one after the other, depending on
the centrifuge type:
■
the centrifuge model and program version
■
When the lid is closed:
■
When the lid is open: The last centrifugation data used.
The rotor is stationary.
Set the mains switch to
Personnel:
■
Trained user
The centrifuge is switched on
The rotor is stationary.
[STOP/OPEN] button.
Press the
�� The lid unlocks by means of a motor.
The light on the left side of the
CAUTION
Danger of crushing when closing the lid.
Danger of crushing fingers when the closing motor pulls the
lid against the seal.
−
No parts of the body should be in the hazard zone of the
lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
−
Close the lid slowly.
−
Do not slam the lid.
When the left side of the [STOP/OPEN] button flashes,
press the [STOP/OPEN] button so that the motorised lid
lock assumes the home position (open).
Personnel:
■
Trained user
Rev.: 04 / 11.2023
[I] .
'OPEN OEFFNEN' indicator
[0] .
[STOP/OPEN] button goes out.
Operation
21 / 40