EMS DOLORCLAST Instructions For Use Manual page 29

2
1
REF DESIGNATION
1 O-rings
2 Applicator
3 Nose
1. Place the O-ring 1a on the applicator.
2. Place the O-ring 1b on the applicator.
1a
3. To make sure that the O-ring is in the correct position,
invert the applicator and check that the O-ring stays
in position.
4. Insert the applicator in the nose.
00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 29 00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 29
3
Figure 64
QUANTITY
2
1
1
Figure 65
Figure 66
Figure 67
8.1.2.2. For 25-mm and 40-mm Applicators
1
REF DESIGNATION
1 Nose
2 O-rings
3 Applicator
4 Nut
1. Remove the applicator from the handpiece.
1b
2. Place the applicator on the support. Make sure to align
the positioning pins on the support with the corre-
sponding pin holes on the applicator. This prevents
the applicator from turning.
There are two pins on the support that need to be
attached to join the applicator.
2
4
3
Figure 68
QUANTITY
1
3
1
1
Figure 69
Figure 70
29
25/03/2021 17:07 25/03/2021 17:07