EMS DOLORCLAST Instructions For Use Manual page 25

6.3.2. Burst Mode 2
Burst mode 2 makes it possible to manually switch
between a set frequency and a frequency of 25Hz.
1. Press the Burst button twice to activate Burst mode 2.
The LED signifies that the mode is enabled.
1.5
1000
1000
SMART PROTOCOL
SMART PROTOCOL
2. To activate Burst mode 2 while delivering the treatment,
press and hold the trigger for more than one second.
Burst mode will remain active as long as you keep
holding the trigger.
3. To deactivate Burst mode 2 and return to the set
frequency, release the trigger.
You can reactivate Burst mode 2 as long as there
are impulses remaining in the treatment.
00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 25 00_FB-656_10_rev_A_IFU_Dolorclast RSW.indb 25
Figure 51
bar
1.5
bar
25
Hz
25
Hz
Impulses
Impulses
Figure 52
25
25/03/2021 17:07 25/03/2021 17:07