Booting Up - RMG TME 400-VM Operating Manual

3 TME 400
3.1.3
It may be necessary to re-boot the device in case of severe faults.
Caution
50
It is necessary to remove the seals, particularly the seal over the calibration
button in order to boot up (see Figure 8: Position of the calibration button).
The TME 400 must only be used for custody transfer with unbroken seal. Re-
moval or damage to seals normally entails considerable expenses!
Re-application of seals must only be carried out by an officially recognized
inspection authority or calibration officials!
Manual TME400-VMF · EN11 · January 22nd, 2024

Booting up

Figure 8: Position of the calibration button