Table of Contents
Advertisement
Danger
Inadequately qualified persons working on the equipment are unable to cor-
rectly estimate dangers. Explosions can be triggered. Only work on the
equipment if you have the appropriate qualifications.
Components can be damaged if you do not use suitable tools and materials.
Use tools that are recommended for the respective work in the operating
manual.
Mechanical installation
Electrical installation
Mechanical and/or
electrical installation
Danger
Installation and removal of the TME 400 must only take place in an explosion-
free, pressure-free atmosphere. The descriptions in the operating manual
must be observed. In general, it is recommended that the replacement should
only be carried out by RMG Service.
A leak test must be carried out after work on pressurized components.
All of the above points also apply to repair and maintenance tasks and in
general when opening the meter is necessary.
Flange fastening elements, fastening screws, screw couplings and check
valves, the oil supply, pressure relief connections, valves, HF pulse genera-
tors, protective pipes and swivel adapters must not be loosened during oper-
ation.
Mechanical installation must only be performed by appro-
priately qualified technicians.
Installation on electrical components must only be carried
out by qualified electricians.
These qualified personnel require training specifically for
work in hazardous areas. Qualified personnel are persons
who have training / education in accordance with DIN
VDE 0105, IEC 364 or comparable standards.
Manual TME400-VMF · EN11 · January 22nd, 2024
1 Introduction
7
Advertisement
Table of Contents
