3 TME 400
3.1.4
Note
The coordinate G24 (see chapter 4.3.3.4 Error / type plate) indicates the re-
maining battery capacity. If the remaining capacity falls below 10 %, a warn-
ing is generated.
52
In order to replace the battery, unscrew the large screw on the right side of the
electronics with a large screwdriver or a coin.
The meter is rotated in the next figure, showing the rear area in this figure below.
Now, you can pull out the battery holder with battery on a handle.
The battery can be removed vertically in relation to the battery holder by pulling
slightly. When installing the new battery, ensure that the polarity is retained for the
new battery.
Manual TME400-VMF · EN11 · January 22nd, 2024
Battery replacement
Figure 9: Position of the battery housing