Display test
3.1.1.
The display test is provided to ensure that all fields of the display function properly.
For this purpose, please press and hold the up arrow and down arrow buttons (
and
) for more than 2 seconds. The following display appears while these but-
tons are held.
Reset
3.1.2.
To reset the system, the voltage supply is interrupted and the TME400 is switched off
for this period. For this purpose, the battery and any existing external voltage supply
are disconnected. The program and operating parameters are not lost in the process
and the meter statuses are saved.
Booting up
3.1.3.
It may be necessary to re-boot the device in case of severe faults.
Figure 7: Display at display test
Manual TME400-VMF · EN07 · December, 7
3 TME400
45
th
2020