Area Of Application - RMG TME 400-VM Operating Manual

1 Introduction
1.3.5
The TME 400 is approved for use in hazardous areas with the following mark:
18
The EC type approval certificate is:
The corresponding conformity certificates are provided in the annex. The RMG con-
tact information is provided on the second and last page.
1.3.5.1
The TME 400-VM and TME 400-VMF can be supplied with DIN and ANSI connec-
tions. Up to nominal diameter DN 200, the installation position of the turbine meter
with permanent lubrication can be selected as required. From nominal diameter
DN 250, the meter must be installed in the ordered installation position. It must also
be ensured that the filling opening of the lubrication faces upwards.
1.3.5.2
The turbine meter TME 400 in standard version is approved for the following temper-
ature ranges.
Temperature ranges
Medium temperature
According to ATEX (T
According to PED 2014/68/EU
Pressure safety for DN25 according
to sound engineering practice, see
PED 2014/68/EU, sec. 4, subsec. 3
Lower temperature limits are available on request with the welded version and round steel material.
Manual TME400-VMF · EN11 · January 22nd, 2024

Area of application

II 2G Ex ia IIC T4 Gb
TÜV 17 ATEX 207566 X
IECEx TUN 18.0009 X
Installation and mounting position
Temperature ranges
)
amb
-25°C to +55°C
-25°C to +55°C (II 2G Ex ia IIC T4)
-20°C to +80°C (spheroidal graphite iron)
-40°C to +80°C (cast steel)
-40°C to +80°C (stainless steel)
-10°C to +80°C (welded version
and round steel material)
-40°C to +60°C (aluminum)