Table of Contents
Advertisement
___________________________________________________
H _o_ m _ e _L _i_ n _k _® _
___.f
9. The emergency flashers will flash three times (after
about 15-60 seconds) when the programming
is
successful. Release the button on the remote control.
-
To program more devices, repeat steps 4 to 9.
10. Press and hold the trained Homelink® button and
observe the indicator light @ => page 102, fig. 81.
-
If the indicator ligh t is solid/continuous,
programming
is
complete and your device should activate when you
press and release the tra ined Homelink® button.
- If the indicator light blinks rapidly for 2 seconds and is
then a solid/continuous
light, proceed with phase 3 to
program a rolling code device.
Phase
3: rolling
code
programming
- A second person on a ladder who can safely reach the
garage door ope ner motor is recommended.
11. Locate the "learn" button on the garage door opener
motor (refer to the operating instructions for the opener,
as the location of this button may
vary
by manufacturer).
12. Press and release the lea rn button on the garage door
opener motor.
-
Note: once the button is pressed, there are 30 seconds in
which to initiate the next step.
13. On the Homelink® keypad inside t he vehicle, firmly
press and hold the Homelink® button previously
programmed
in phases 1 and 2 for two seconds and
release. Repeat this sequence twice .
Controls and equip-
ment
-
Some vehicles may require the press/hold/release
sequence up to three times to complete the training
process.
-
Homelink® should now activate your rolling code
equipped device.
If the 5 minute time limit is exceeded, the emergency flashers will
flash one time to indicate that the process has been terminated . In
this case, repeat steps 4 through 9.
If the emergency flashers do not flash
three
times (after about 15-
60 seconds), programming
was not successful. In this case, repeat
steps 4 through 9.
Remote control units for garage door openers in Canada are set to
stop transmitting
radio frequency signals after two seconds. This
time may not be sufficient for the Hom eLink® system to learn the
radio frequency signal. Perform all other steps as described
above. •
Ap pli es to ve hi cles: w it h Homel ink® univ ersal remo te co ntro l
Operating
the HomeLink
® transmitter
The Homelink®
transmitter
works in the same manner as
the original
handheld remote control that came with the
system.
~--------------=
1
... . ..
······
{:::::;
. • .•. ..
,
..
,,,
..
,. .....
Vehicle care
I
I
.,,.
....
~
.
..... .
::::::: 1
j•:: : ,~
Fig. 83 Close-up:
Homelink® keypad
irechnical data
Advertisement
Table of Contents
