Data I/O 298 Manual page 83

3. "HHHH" in the display is the hex address in RAM
where the data can be editted. "DHH" is the hex data
programmed into the device at the selected address
{**
for data means that address is undefined in the
device). 'RHH' is the present hex data in the selected
RAM
address. To enter the new hex data for the
selected address, enter data in the sequence:
HH(CR)
298 Displays
HHHH IIHH,, RHH
New address is previous address plus one. Data is
from new address.
The terminal displays data in the following sequence:
EDIT ADDR 0000 >
HHHH DHH,RHH >
HHHH DHH,RHH >
As long as new data is input followed by a return (CR)
the address counter will be incremented by one for the
next address. Exit the edit mode by pressing another
mode key.
NOTE
If
the data displayed is not to be
changed, enter a carriage return (CR) to
increment to the next data location or a
slash (I) to decrement to the previous
data location.
SELECT COMMANDS. Select Commands can be entered
with SRC by selecting either (S) (E) (space) (select hex
code) (CR), or by entering directly the first two characters
of the select command followed by a carriage return (CR).
Entering (S) (E) (CR) will display a menu of all select
codes. Refer to table 3-15 for a listing of the format codes.
Use one of the following examples which illustrate the two
methods to enter a select code.
• The following example shows how to enter the Clear All
RAM select function using the hex code:
Enter: SE(SP)A4(CR).
NOTE
Always enter space bar between
USE"
and the hex code.
298 Displays
(CLERR RLL
RRr1
*.~)
The terminal displays a prompt (>).
• The following example shows how to enter the Clear All
RAM seiect mode using the first two characteis of the
select command.
Enter: CL(CR).
29B Displays
(CLEAR RLL RRr1
10~)
The terminal displays a prompt(>).
Table 3-14. Select Commands
HEX
CODE CODE TITLE
A1 SW
Swap Nibbles
A2 Fl Fill RAM
A3 IN Invert RAM
A4
CL Clear All RAM
A5 SP Split RAM
A6 SH Shuffle RAM
BO DE
Device Size
B1 SU Sumcheck RAM
B2 SY System Config
B3
FO Format Number
84 NO Nonblank Fail
B9
Di Display Test
C1
CA Calibration
D7 LE Leader Output
DB
SI Size Record
D9 NU Null Count
FO PR Program Count
F1 RE Remote Mode
F2
29 29B TRC
F3 LO Lock Data On
F4 NI Nibble Mode
F5
Bl Binary Base
F6 OC Octal Base
F7 HE Hex Base
F8
BY Byte/Nib Mode
F9
Tl Timeout Off
FA CH Char Output
FB EN Enable Port
FC
RE Remote On Off
3-57
10-990-0013