Data I/O 298 Manual page 50

81 SUMCHECK RAM Command
Use the following procedure to display the total RAM
sumcheck:
1.E??1
8
to select the select function.
298 Displays
(_S_E_-_L_E_-_[_T_L_r_o_D_E_-__ " _ __, , )
The prompt ( /\) following "SELECT CODE" on the
display means that the two character hex select function
code must be entered before the procedure can continue.
2.E??:1
to select the RAM sumcheck function.
298 Displays
(SELECT CODE
3.E?,
to display the RAM sumcheck in hex.
298 Displays
~·
1MruE-ru
_,ur
IL
fl
-L (\
HHHH
HHHH represents the hex value of the total RAM
sumcheck.
82 SYSTEM CONFIG Command
Use the following procedure to display the four character
system configuration code:
to select the select function.
298 Displays
(SELECT rnTIE
LU.LI
I\
)
The prompt ( /\) following "SELECT CODE" on the
display means that the two character hex select function
code must be entered before the procedure can
continue.
2.
E?:J
to select the system configuration function.
298 Displays
(SELE[
T
CODE
3.
E??:i
298 Displays
(HHHH
HH~(
29B
VHH)
to display the four character system configuration
code (HHHH), RAM size (HHK), Model (298), and
version number (VHH).
83 FORMAT NUMBER Command
The 1/0 format can be selected in either of three ways. If
the desired format number is known the select mode can
be accessed and the code entered directly. The indirect
methods allows the operator to display the current or
default entry and then change the entry by either stepping
through the formats, or entering the format code. Refer to
Appendix A to determine which instrument control code
and format code is desired.
Use the following procedure to enter a new data translation
format number directly:
1.
E?::::1 8
to select the select function.
298 Displays
( __ S_E_L_E_-_[_T __
[_O_D_(_~
___ " _ ___. )
The prompt ( /\) following "SELECT CODE" on the
display means that the two character hex select function
code must be entered before the procedure can
continue.
3-24
10-990-0013