Other Commands - Data I/O 298 Manual

C.9.8 VERIFY DEVICE'S DATA WITH 298
RAM DATA
Front Panel Control
To verify device(s) with data from the 29B's
RAM,
proceed
as follows:
1. Set up the handler for the type of devices to be verified
(set device width, binning controls, etc.).
2. Insert the device{s) into the top of the handler. See the
handler manual for details on device insertion.
3. Start the handler.
4. Perform the "Verify Device Data with 298 RAM Data"
procedure given in section 3.6.6 of this manual, with
one exception: Step 6 calls for device insertion. Ignore
this step, since the devices to be verified are already in
the handler.
NOTE
Devices will be automatically verified or
failed as long as the handler continues to
feed them. The verified or failed devices
will be automatically binned as described
in section C.9.4.
CRC Mode
To verify device(s) with data from the 298's RAM while in
CRC mode, proceed as follows:
1 . Set up the handler for the type of devices to be verified
(set device width, binning controls, etc.).
2. Insert the device(s) into the top of the handler. See the
handler manual for details on device insertion.
3. Start the handler.
4. issue the family and pinout codes fo; the device (using
the "@" command} if they are not already entered (see
section 3.9.1 for details).
5. Issue the Verify command: "V[CR]".
6. The 298 programmer will respond with one of three
characters:
"> ",
"F" or
"?".
See section 3.9.1 for
details on CRC.
7. Issue a binning command ( 1 ! , 2!, 3! or 4!) to bin the
device.
8. If the "%" function has been enabled, wait for the 298
to issue a
">"
prompt. If this function is not being
used, wait until the next device is ready.
9. Repeat steps
5
through
8
until all devices have been
verified.
C.10 OTHER COMMANDS
Commands other than the Load, Program and Verify
mentioned in this appendix operate in the same way for
handler operation as they do for non-handler operation.
See section 3 of this manual for key sequences and
terminal commands for other operations.
C-11
10-990-0013