Data I/O 298 Manual page 61

4.E:=J
to enter the hex code for the ASCII character to be
transmitted. (Step can be skipped if the default
entry is correct.)
298 Displays
(i-1
IOfJ
1.,Lr-lr-lf\
5.
E??::1
298 Displays
n11rp11r
ULJI LJI
[Hill~ OUTPUT
"HH)
~HH
the prompt flashes momentarily.
298 Displays
CHRI~
OUTPUT
6. To retransmit the same character return to step 5. To
transmit a different character return to step 4.
FB ENABLE PORT Command
Use the following procedure to enable system remote
control and input interrupt. This also forces the RTS line
high at all times for remote control from peripherals
requiring a hardware handshake. The default at power-up
is RTS low and system remote control and serial interrupts
disabled.
1.E?i
B
to select the select function.
298 Displays
(
,- r
1 ,- ,- r ,- ,-,
n ,-
:JC LC
LI LU.!JC
I\
)
The prompt ( /\) following "SELECT CODE" on the
display means that the two character hex select function
code must be entered before the procedure can
continue.
~~
II F II II B II
~ lhdJ
2,
c::;,.,
to select the enable port function.
298 Displays
[UIJE
3.F?J
G
298 Displays
(ErJRBLE
PORT
F B)
4.E?:i
298 Displays
(ErJFIBLE POl~T
the system remote control is enabled.
FC REMOTE ON OFF Command
Use the following procedure to enter hex codes for ASCII
characters that can be used to turn remote control on or
off (may be used with CRC, SRC or TRC):
1.E'J
B
to select the select function.
298 Displays
(~S_E_-_L_E_-L_r_r~_[_O~]_E_-~~"~~)
The prompt ( /\) following "SELECT CODE" on the
display means that the two character hex select function
code must be entered before the procedure can
continue.
2.
E?J
to select the remote on or off function.
298 Displays
(SELECT CODE
3-35
10-990-0013