Connecting A Computer Or Terminal To The 29B; Power-Up; Installing The Performance Board-Delta Handler - Data I/O 298 Manual

~--....._ _ _ _ PERFORMANCE
BOARD
SOCKET
Figure C-6. Installing the Performance Board-Delta Handler
C.7.4 CONNECTING A COMPUTER OR TERMINAL
TO THE 29B
Commands can be issued to the 298 via a computer or
terminal using Computer Remote Control (CRC). To
operate the 298 via computer, the user will have to provide
special interface software. If you wish to perform
operations with the system using a computer or terminal,
connect an RS232C transmission cable between the 298
and the computer or terminal. See section 2.5 of this
manual for cable installation details, and section 3.9.1 for
more information on CRC.
C.8 POWER UP
CAUTION
Voltage transients can damage a
device. Be sure the performance
board and the handler are free of
devices before you apply power to
the system or before you install or
remove the Handler UniPak™.
To power up the system, follow the procedures given in
this manual {sections 2.4 and 3.2.2i and the handler's
manuals.
C-7
10-990-0013