Block Move - Data I/O 298 Manual

Table E-1. Error Codes (Continued)
DISPLAY
DESCRIPTION
.
CORRECTIVE ACTION
BLOCK MOVE ERR 97 Block Move was attempted outside RAM
Redefine parameters.
boundaries.
DEV EXCEEDED 98 Programming data exceeded the last device
Redefine parameters.
address.
ERRORS AID thru A9
These are pak-related errors. Refer to your Refer to your programming pak manual.
programming pak manual.
110 FORM ERR
93 The number of input records did not equal Check the connection of all units in the system,
the Record Count (MOS Technology format data format, and data source, and then try
only). again.)
BAD REC TYPE
94 The record type was in error. (Intel- Check the connection of all units in the system,
lntellec 8/MDS, Intel MCS-86 and T.I. data format, and data source, and then try
SDSMAC formats only.) again.
ERROR
96* Illegal center point for RAM shuffle. Check parameters and re-enter.
*Remote Control only; will not occur during front panel operation, hence no front panel display.
E-5
10-990-0013