Trip Alarm - Smartgen HGM9560 User Manual

6.3 TRIP ALARM

On initiation of the trip condition the controller will de-energize the 'Close Generator' Output without stop the
generator.
No. Type
1 Digital Input
2 Fail to sync
3 Bus Breaker Fail
4 Mains Breaker Fail
5 Insufficient Capacity
6.4 MAINS TRIP ALARM
When controller detects the signal of mains trip, it will realize the output of mains open.
No. Type
Mains Trip of Input
1
Port
Output Mains Power
2
Limit
Mains Over Current 1
3
Trip
Mains Over Current 2
4
Trip
HGM9560 Bus Tie Mains Parallel Unit
Table 9 Trip Alarms
When the digit input port is set as user configured and the action select
"Trip", it will initiate a trip alarm.
When the controller does not detect synchronization signal within the
pre-set synchronization time, it will initiate a trip alarm.
When the controller detects that the Bus Breaker Fail is not configured in
the input port, it will initiate a trip alarm.
When the controller detects that the Mains Breaker Fail is not configured in
the input port, it will initiate a trip alarm.
When the controller detects that the bus power percentage has exceeded
100%, and the action select "Trip", it will initiate a trip alarm.
Table 10 Mains Trip
When digital input port selection is user defined and the configuration is
mains trip, the controller will initiate a signal of mains trip after the input
port is active.
When the controller detects that the mains power has exceeded the
pre-set value, and the action select "Trip and Stop", it will initiate a trip
and stop alarm.
When the current of any phase of mains is over than the over current 1
pre-set value, and the action selects" Mains Trip", it will initiate a tripping
signal.
When the current of any phase of mains is over than the over current 2
pre-set value, and the action selects" Mains Trip", it will initiate a tripping
signal.
Description
Description
Page 20 of 47