Trip Alarm; Wiring Connection - Smartgen HGM8156 User Manual

6.4 TRIP ALARM

When controller detects trip alarm signal, it immediately disconnects the bus close signal, but genset
doesn't stop.
No. Type
1 Maintenance Time Due
2 Digital Input
3 Gen Breaker Fail
4 Mains Breaker Fail
7

WIRING CONNECTION

Controller back panel is as below:
HGM8156 Genset Parallel (With Mains) Controller
HGM8156 GENSET PARALLEL CONTROLLER USER MANUAL
Table 11 Trip Alarms
When maintenance countdown is 0 and action is selected to Trip,
controller will initiate a trip alarm.
When digit input port is set as "Trip" and the alarm is active, it will initiate
a trip alarm.
When controller detects gen breaker close/open fails, it will initiate a trip
alarm.
When controller detects mains breaker close/open fails, it will initiate a
trip alarm.
Fig. 1 Controller Back Panel
Description
2019-09-10 Version 1.1 Page 18 of 44