Figure 8-19. Smt Pad Trace Between; Figure 8-20. Connector Voiding; Table 8-6. Hdmi Signal Connections - Nvidia Jetson Xavier NX Design Manual

Figure 8-19. SMT Pad Trace Between

Figure 8-20. Connector Voiding

Table 8-6. HDMI Signal Connections
Module Pin Name Type
DPx_TXD3_N/P DIFF
OUT
DPx_TXD[2:0]_N/P DIFF
OUT
DPx_HPD I
HDMI_CEC I/OD
DPx_AUX_N/P I/OD
HDMI 5V Supply P
Note: Any ESD and/or EMI solutions must support targeted modes (frequencies).
NVIDIA Jetson Xavier NX
Termination (see note on ESD)
0.1uF series AC → 500Ω R
CAP PD
→ ESD to GND →.≤6Ω R (series resistor)
S
From module pin: 10kΩ PU to 1.8V → level shifter
→ 100kΩ series resistor. 100kΩ to GND on
connector side → 100pF/12pF caps to GND → ESD
to GND.
Gating circuitry, See connection figure for details.
From module pins: 10kΩ PU to 3.3V → level shifter
→ 1.8kΩ PU to 5V → ESD to GND
Adequate decoupling (0.1uF and 10uF
recommended) on supply near connector and ESD
to GND.
Description
(controlled by FET) HDMI Differential Clock: Connect to C–
/C+ and pins on HDMI connector
HDMI Differential Data: Connect to
HDMI Data pins (See Table 8-2)
HDMI Hot Plug Detect: Connect to HPD
pin on HDMI connector
HDMI Consumer Electronics Control:
Connect to CEC on HDMI connector
through circuitry.
HDMI: DDC Interface – Clock and Data:
Connect DP1_AUX_N to SDA and
DP1_AUX_P to SCL on HDMI connector
HDMI 5V supply to connector: Connect to
+5V on HDMI connector.
Display
DG-09693-001_v1.7 | 53