Anti-Collision Lights (Warrior/Warrior Ii); Anti-Collision Lights Description (Warrior/Warrior Ii); Removal Of Wing Tip Strobe (Warrior/Warrior Ii); Installation Of Wing Tip Strobe (Warrior/Warrior Ii) - Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual

Airplane
Table of Contents

Advertisement

PIPER CHEROKEE WARRIOR SERV I C E M A N U A L
c. Set (push in) NAV LIGHTS circuit breaker.
d. Verify that bulb(s) is/are working by selecting BATT MASTR and NAV LIGHT switches ON and
checking that all navigation light bulbs are lit. Select BATT MASTR and NAV LIGHT switches OFF.
e. Locate lenses over appropriate bulbs and position cover plate over lenses and light fixture. Be
sure that the red lens (right wing) or green lens (left wing) is located over the forward bulb
f. Install cover plate over lenses and secure with the two screws removed in Paragraph 11-91 (c).
11-100. ANTI-COLLISION LIGHTS
11-101. ANTI-COLLISION LIGHTS DESCRIPTION. (WARRIOR/WARRIOR II)
The Warrior/Warrior II airplanes were equipped with strobe type anti-collision lights located on each
wing tip in the same assembly with the navigation lights, and in an independent mounting on the vertical
s t abilizer, or a rotating beacon type anti-collision light installed on the tip of the vertical stabilizer. They strobe
type are rated to flash at approximately 50 times per minute. There is just one power supply for all strobe
lights. (Refer to Figures 11-55 or 11-56.)
11-102. REMOVAL OF WING TIP STROBE LIGHT. (WARRIOR/WARRIOR II)
a. Be sure electrical power is removed from aircraft and/or applicable system.
b. Remove the screw securing the navigation light cover and remove cover.
c. Remove the three screws securing navigation light bracket assembly and pull out.
d. Remove the strobe lamp by cutting the wires on the lamp beneath the mounting bracket.
e. Remove the defective lamp.
f. Remove and discard the plug with the cut wires from its electrical socket.
11-103. INSTALLATION OF WING TIP STROBE LIGHT. (WARRIOR/WARRIOR II)
a. Route the wires from the new lamp down through the hole in the navigation light bracket.
b. Insert the wire terminals in the plastic plug supplied with the new lamp. Wire according to the
schematic diagram located in the back of this section.
c. Position strobe lamp on navigation light bracket.
d. Secure navigation light assembly and bracket with appropriate screws.
e. Set Anti-Collision Lights circuit breaker.
f. Verify that bulb(s) is/are working by selecting the Battery Master and Strobe Light switches On,
and checking that both strobe lights flash. Select Battery Master and Strobe Light switches Off.
g. Install navigation light cover and secure with appropriate screw.
11-104 REMOVAL OF FIN TIP STROBE LIGHT. (WARRIOR/WARRIOR II)
a. Be sure electrical power is removed from aircraft and/or applicable system.
b. Remove clamp securing lens to mounting plate on fin tip.
c. Remove lens from strobe light assembly.
d. Remove screws securing fin tip to fin.
e. Lift up fin tip and disconnect electrical plug.
f. Pull Strobe light assembly out of fin tip, electrical plug will pull up through hole in middle of
mounting plate.
11-105. INSTALLATION OF FIN TIP STROBE LIGHT. (WARRIOR/WARRIOR II)
a. Insert new electrical plug down through hole in mounting plate and position strobe light assembly
in place.
b. Position lens in place.
Revised: February 28, 1995
2G6
Island Enterprises
ELECTRICAL SYSTEM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Warrior ii pa-28-161 1995Warrior iii pa-28-161 1995

Table of Contents