Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 447

PIPER CHEROKEE WARRIOR SERVICE MANUAL
11-130. REPLACEMENT OF ANNUNCIATOR PANEL LIGHT BULBS (WARRIOR III)
It is not necessary to remove the annunciator panel assembly to replace lamp bulbs. Simply "PUSH-
IN" on the function light until it "clicks", and release pressure. The cover assembly will be partially ejected
from the lamp base assembly. Pull the cover from the base and rotate to expose the lamp bulbs. Replace
defective bulb(s) and reverse removal procedure. Select BATT MASTR switch ON; then depress "Test"
switch to verify lamp is functioning.
TO ANNUNCIATOR
PANEL
Added: February 28, 1995
(OPTIONAL)
LOW BUS PITOT HEAT
VOLTAGE OFF/INOP
ALTERNATOR
VACUUM
INOP
CARB ICE
(OPTIONAL)
5 W
560
(11 REQ'D)
K1 K2
IN2071A
DIODE
(5 REQ'D)
Figure 11-59. Annunciator Panel and Box Assembly
(Warrior III)
2G16
Island Enterprises
STARTER
ENGAGE
OIL
INOP
PRESSURE
K3
K5
K4
ELECTRICAL SYSTEM