Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 124

PIPER CHEROKEE WARRIOR SERVICE MANUAL
7 . Remove masking tape if used, and clean off excessive adhesive using a clean cloth and mineral
spirits or Toluol.
8. Install the striker plate.
9. Reposition the windlace and secure with retainers previously removed.
10. Install the scuff plate and door holder previously removed.
11. Adjust the door latch to compensate for the snubber ensuring a good door to fuselage contour
fit with no increase in latching effort.
12. After all adjustments and curing have been accomplished, coat the snubber with silicone-wipe
off any excess.
4-48. BAGGAGE DOOR.
4-49. R E M O VAL OF BAGGAGE DOOR. With the door open remove the hinge pin from the hinge and
remove the door.
4-5 0 . I N S TA L L ATION OF BAGGAGE DOOR. Place the door in position so that the hinge halves are
p r o perly matched and install the hinge pin. It will not be necessary to replace the hinge pin with a new pin if it
is free of bends and wear.
4-51. REMOVAL OF BAGGAGE DOOR LOCK ASSEMBLY.
a. With the door open remove the nut from the back of the lock assembly by use of a special made
wrench. (This tool may be fabricated from the dimensions given in Figure 4-9.)
b. Remove the lock assembly through the front of the door.
4-52. INSTALLATION OF BAGGAGE DOOR LOCK ASSEMBLY.
a. Place the lock into position for installation.
b. Install the nut on the lock assembly and tighten with the use of a special wrench.
4-53. REMOVAL OF BAGGAGE DOOR HINGE.
a. Remove the door from the airplane as described in Removal of Baggage Door. Paragraph 4-49.
b. Remove the hinge half from the airplane or door by drilling out the rivets and removing the hinge .
4-54. NSTALLATION OF BAGGAGE DOOR HINGE.
a. Place the hinge halves together and install the hinge pin.
b. Install the door into the closed position and drill the two end river holes and install the rivets.
c . Operate the door and check for proper fit and installation. Drill the remaining holes and
install the rivets.
4-54a. RIGGING INSTRUCTIONS - SEAT BACK LOCK AND RELEASE. (Refer to Figure 4-10a)
a. Loosen screws (1 and 2) and ascertain that clamps (3 and 4) are in a relaxed condition. (Push-pull
cable (6) is able to move within the clamps.)
b. Place a straightedge along the lower surface of bushing (5) of the seatback release.
c. Adjust the push-pull cable (6) by raising or lowering it until the lower surface of the stop assembly
(7) is parallel to the straightedge.
d. Secure the push-pull cable in this position by tightening screws (1 and 2) on clamps (3 and 4). The
stop (7) should be lubricated and free to swivel without excessive play.
e. Push on seat back with stop assembly (7) in an engaged position, to check engagement. Rotate the
seat back release handle and check for disengagement of seat back.
Revised: February 28, 1995
1F4
Island Enterprises
STRUCTURES