Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 219

PIPER CHEROKEE WARRIOR SERVICE MANUAL
1. SNAP RING
2. GREASE RETAINER RING
3. FELT RING
4. GREASE SEAL RING
5. BEARING CUP
6. BEARING CONE
7. OUTER WHEEL HALF
8. INNER WHEEL HALF
9. BEARING CUP
10. BEARING CONE
11. GREASE SEAL RING
12. FELT RING
13. GREASE RETAINER RING
14. SNAP RING
15. BRAKE DISC
16. BOLT
17. WASHERS
18. NUT
7-26. ASSEMBLY AND INSTALLATION OF MAIN WHEEL. (Refer to Figure 7-8.)
a. Ensure that the bearing cup (5 or 9) for each wheel is properly installed. Install the tire with tube
on the outer wheel half (7) and then join the two wheel halves. Position the brake disc (15) in the inner wheel
half and install the through bolts with the nuts on the valve stem side. Torque wheel nuts to 150 inch pounds.
b. Position the tire and tube so the index mark on the tire is aligned with the index mark on the tube.
This will maintain proper balance of the wheel. Inflate the tire to the specified pressure as given in Table II-I
of Section II.
c. Lubricate the bearing cones (6 or 10) and install the cones, grease seals (4 or 11), seal retainer
rings (2 or 13) and felt rings (3 or 12). Secure with snap rings (1 or 14).
d. Slide the wheel on the axle and secure with retainer nut. Tighten the nut to allow no side play, yet
allow the wheel to rotate freely. Safety the nut with a cotter pin and install a dust cover.
Revised: June 16, 1979
Figure 7-8. Main Wheel Assembly
1J3
Island Enterprises
LANDING GEAR AND BRAKE SYSTEM