Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 160

PIPER CHEROKEE WARRIOR SERVICE MANUAL
CABLE WEAR
d. Corrosion
Carefully examine any cable for corrosion that has a broken wire in a section not in contact with
wear producing airframe components such as pulleys, fairleads, etc. It may be necessary to remove and bend
the cable to properly inspect it for internal strand corrosion as this condition is usually not evident on the outer
surface of the cable. Replace cable segments if internal strand rust or corrosion is found.
Areas especially conducive to cable corrosion are battery compartments, lavatories, wheel wells,
etc., where concentrations of corrosive fumes, vapors, and liquids can accumulate.
Check all exposed sections of cable for corrosion after a clean -
ing and/or metal-brightening operation has been accomplished
in that area.
Added: February 28, 1995
Figure 5-4. Internal Cable Wear
NOTE
THIS SPACE INTENTIONALLY LEFT BLANK
1G16
Island Enterprises
CABLE WEAR
SURFACE CONTROLS