Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 244

Airplane
Table of Contents

Advertisement

PIPER CHEROKEE WARRIOR SERVICE MANUAL
c . Assemble the engine shock mounts as shown in Figure 8-4. Note the position of each mount
c a r efully. The upper right and lower left mounts are installed the same. The upper left and lower right are
installed the same.
d. Swing the engine into place and position the engine mounting lugs so they align with the engine
mount attachment points.
e. Position the shock mount bolts through the mounting lugs and secure with nuts. Torque the nuts
progressively, following a circular sequence until a torque value of 450-500 inch pounds is reached.
f. Connect the alternator leads and secure cables with clamps.
g. Connect the oil pressure line, tachometer drive cable oil temperature lead and the engine vent tube
to the aft end of the engine.
h. Connect the vacuum pump line at the pump.
i.
Secure the ignition harness, hoses and lines at the aft end of the engine using koroseal lacing.
j.
Connect both lines to the oil cooler. Use a back up wrench on the cooler fitting.
k. Connect the mechanical fuel pump supply line at the pump.
1. Connect the magneto "P" leads to the magnetos.
m. Connect the throttle mixture and carburetor heat cables at the engine components.
n. Connect the cabin heat and defroster tubes to the muffler.
o. Connect the starter positive and ground leads at the starter and secure with attachment clamps.
p. Be certain that the magneto switches are OFF and install the propeller per paragraph 8-7.
Refer to the latest revision of Textron Lycoming Service
Instruction No. 1014 for appropriate oil grades and permissible
additives.
q. Install the proper grade and amount of engine oil.
r.
Connect the battery ground wire at the battery.
s. Open the throttle and fuel valve completely. Turn on the electric fuel pump and check the fuel line
for leaks.
t.
Install the engine cowlings and remove the tail stand.
To avoid possible high speed bearing failure due to lack of
lubrication refer to the latest revision of Lycoming Service
Instruction 1241 for instructions on pre-oiling the engine prior
to initial start after engine installation.
u . Perform an engine operational check. Refer to appropriate engine manufacturer's operator's manual.
8-12.
INSTALLATION OF ENGINE SHOCK MOUNTS. (Refer to Figure 8-4.)
a. Assemble the engine shock mounts on the engine mount as shown in Figure 8-4. Note the position
of each mount carefully. The upper right and lower left mounts are the same, as are the upper left and lower
right.
b. Swing the engine into place, positioning the engine mounting lugs so they align with the engine
mount attachment points.
c. Position the shock mount bolts through the mounting lugs and secure with nuts. Torque the nuts
progressively following a circular sequence until a torque value of 450-500 inch pounds is reached.
Revised: February 28, 1995
NOTE
CAUTION
1K4
Island Enterprises
POWER PLANT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Warrior ii pa-28-161 1995Warrior iii pa-28-161 1995

Table of Contents