Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 109

PIPER CHEROKEE WARRIOR SERVICE MANUAL
m. Connect the electrical leads to the appropriate posts on the terminal strip and install the washers
and nuts. (For assistance in connecting the electrical lead, refer to the Electrical Schematics in Section XI.)
Place the clamps along the electrical harness to secure it in position and install the terminal strip dust cover.
n. Remove the cap from the fuel line and connect it at the fitting located aft of the spar at the wing
butt line.
o. Connect the aileron balance and control cables at the turnbuckles that are located within the fuse-
lage aft of the spar. After the left balance cable has been inserted through the bracket assembly and connected,
install a cotter pin cable guard into the hole that is provided in the bracket assembly.
p. Connect the flap by placing the flap handle in the full flap down position; place the bushing on the
outside of the rod end bearing and insert and tighten the bolt.
q. Check the rigging and control cable tension of the ailerons and flaps. (Refer to Section V for rig-
ging and adjustments of the appropriate control systems and cable tensions.)
r. Service and refill the brake system with hydraulic fluid. (Refer to Section II, Servicing Brake
System.) Bleed the system per instructions given in Section VII, and check the system for leaks.
s. Service and fin the fuel system. (Refer to Section II, Servicing Fuel System.) Open the fuel valve
and check for leaks and fuel flow.
t. Check the operation of ad electrical equipment and pitot and static system.
u. Remove the airplane from the jacks.
v. Install the cockpit trim panel assembly, spar box carpet, the front and back seats, and wing butt
rubber molding.
w. Install all access plates and panels on the wing involved.
Revised: February 28, 1995
THIS SPACE INTENTIONALLY LEFT BLANK
1E13
Island Enterprises
STRUCTURES