Piper CHEROKEE WARRIOR PA-28-151 1995 Maintenance Manual page 115

PIPER CHEROKEE WARRIOR SERVICE MANUAL
4-19. INSTALLATION OF STABILATOR. (Refer to Figure 4-5.)
A clearance of 0.25 ± 0.06 of an inch between the stabilator
and the side of the fuselage and .18 of an inch minimum
between all parts of the stabilator and the tail cone assembly
must be maintained throughout the stabilator travel. Use a
proper washer combination on the stabilator hinges to attain
the necessary tolerance.
a. Insert the stabilator in position and install attaching hinge bolts, washers and nuts.
b. Move the trim assembly through the cutout in the stabilator and attach the brackets of the assem-
bly to the aft bulkhead with bolts, washers and nuts. Insert the trim cable ends into the fuselage.
c. Attach the stabilator control cables to the stabilator balance arm with clevis bolts, bushings, wash-
ers, nuts and cotter pins.
d. Connect the ends of the fore and aft trim cables at the turnbuckles within the aft section of the
fuselage.
e. Remove the cable block from the trim control cable within the fuselage.
f. Set stabilator control cable tension and check rigging and adjustment according to Rigging and
Adjustment of Stabilator, Section V.
g. Remove the cable blocks from the trim cable at the barrel of the trim screw assembly.
h. Set stabilator trim control cable tension and check rigging and adjustment according to Rigging
and Adjustment of Stabilator Trim, Section V.
i. Remove the pad from the aft section of the fuselage and replace the access panel.
j. Install the tail cone fairing and remove the tail stand.
Isued: February 28, 1995
Figure 4-4. Methods of Securing Control Cables
NOTE
1E19
Island Enterprises
STRUCTURES