Introduction To Inverter Parameters - Goodwe XS Series User Manual

System Commissioning

8.2.2 Introduction to Inverter Parameters

Parameters
Normal
****-**-**
**:**:**
VPv
IPv
Vac
Iac
Fac
E-Today
E-Total
Serial Number
GW700-XS-30
RSSI:xx%
Firmware M/S
Comm Version
Set Language
Set Safety
Set Date
Set Time
W/L Reset
W/L Reload
PF Adjust
SetModbusAddr
Set ISO
LVRT
HVRT
Power Limit
SetPowerLimit
Description
Home page. Indicates the real-time power of the inverter.
Check the time of the country/region.
Check the DC input voltage of the inverter.
Check the DC input current of the inverter.
Check the voltage of the utility grid.
Check the AC output current of the inverter.
Check the frequency of the utility grid.
Check the generated power of the system for that day.
Check the total generated power of the system.
Check the serial number of the inverter.
Check the signal strength of the communication module.
Check the firmware version.
Check the ARM software version.
Set according to actual needs.
Set the safety country/region in compliance with the local grid
standards and application scenario of the inverter.
Set time according to the actual time in the country/region where the
inverter is located.
Power off and restart the communication module.
Restore the factory settings of the communication module.
Reconfigure the communication module network parameters after
restoring the factory settings,
Set the power factor of the inverter according to the actual situation.
Set the actual Modbus address.
Indicates the PV-PE insulation resistance threshold value. When the
detected value is under the set value, the ISO fault occurs.
With LVRT on, the inverter will stay connected with the utility grid
after a short-term utility grid low voltage exception occurs.
With HVRT on, the inverter will stay connected with the utility grid
after a short-term utility grid high voltage exception occurs.
Set the power feed back into the utility grid according to the actual
situation.
User Manual V1.1-2023-12-30
38