Ac Side; Inverter - Goodwe XS Series User Manual

Safety Precaution

2.3 AC Side

• The voltage and frequency at the connecting point should meet the on-grid requirements.
• Additional protective devices like circuit breakers or fuses are recommended on the
AC side. The specification of the protective device must be greater than 1.25 times the
maximum output current of the inverter.
• The protective grounding cable of the inverter must be firmly connected. When multiple
inverters are used, ensure that the protective grounding points of all inverter chassis shells
are equipotentially connected.
• You are recommended to use copper core cables as AC output cables. Contact the
manufacturer if you want to use other cables.

2.4 Inverter

• Do not apply mechanical load to the terminals, otherwise the terminals can be damaged.
• All labels and warning marks should be visible after the installation. Do not cover, scrawl,
or damage any label on the equipment.
• Do not disassemble, modify, or replace any part of the inverter without official
authorization from the manufacturer. Otherwise, it may cause damage to the equipment,
which shall not be borne by the manufacturer.
• Inverters are prohibited from being installed in multi-phase scenarios.
• Warning labels on the inverter are as follows:
HIGH VOLTAGE HAZARD. High
voltage exists during the
inverter's running. Disconnect
all incoming power and turn off
the product before working on it.
Read through the user manual
before any operations.
High-temperature hazard. Do
not touch the product under
operation to avoid being burnt.
CE Mark.
RCM Mark.
WARNING
DANGER
-
4
User Manual V1.1-2023-12-30
Delayed discharge. Wait
5 minutes after power off
until the components are
completely discharged.
Potential risks exist. Wear
proper Personnel Protective
Equipment before any
operations.
Grounding point.
Do not dispose of the inverter
as household waste.Dispose
of the product in compliance
with local laws and regulations,
or send it back to the
manufacturer.
-